Popular Articles
How to get and apply a License on a Keypanel
How to get and apply a License on a Keypanel Get the MAC address 1. To get the MAC address of the Key panel, enter the menu with the “MENU” button. 2. Select “Display” and press “SEL” 3. Select “MAC Address” and press “SEL” 4. Write down this MAC ...
How to connect an OMNEO Unit to a Matrix
The document will show you the use of IPedit to connect a unit to a matrix and vice versa. These steps are valid for all OMNEO devices. The matrix can be ODIN, OMS or an OMI card in an ADAM(-M) frame. Open IPedit and select the Network Interface Card ...
Authentication bypass on OMS
Authentication bypass on OMS Push and hold ENC1, the encoder left of the display, while resetting the unit with a paperclip in the front panel hole or performing a power cycle. Release ENC1 when you see the splash screen. (pressing CLR while booting ...
How to Run the bootloader of a Key Panel
How to Run the bootloader of a Key Panel To run the bootloader, do the following: 1. Power off the keypanel. 2. Verify the KP-5032/4016 is powered off, but still connected to the FRAME. 3. At the same time, press and hold keypanel key 15 in the ...
Factory default
Factory default In general, resets and Factory Defaults for any OMNEO device can be done with Dante Controller. To do a Factory default including or excluding network settings via DANTE Controller: Double click the unit in Dante Controller Select the ...