Authentication bypass on OMS

Authentication bypass on OMS

Authentication bypass on OMS

 

  1. Push and hold ENC1, the encoder left of the display, while resetting the unit with a paperclip in the front panel hole or performing a power cycle.
  2. Release ENC1 when you see the splash screen.
     (pressing CLR while booting will show the boot sequence)
  3. Push the MENU button when the unit is started.
  4. The unit will show you "Authentication bypassed!"
  5. Choose CLR to disable Authentication without authentication or SEL to re-enable authentication.

 

    • Related Articles

    • How to change Splash screen and Screen Saver Logo's (A/C Only)

      How to change Splash screen and Screen Saver Logo's (A/C Only) Sizes: Series Splash Screen Saver KP-4016 576 x 90 192 x 60 KP-5032 576 x 90 192 x 130 ODIN/OMS 576 x90 576 x 90 Formats: BMP, JPG, TIF, GIF, PNG The unit centers the picture and fills ...

    • How to connect an OMNEO Unit to a Matrix

      The document will show you the use of IPedit to connect a unit to a matrix and vice versa. These steps are valid for all OMNEO devices. The matrix can be ODIN, OMS or an OMI card in an ADAM(-M) frame. Open IPedit and select the Network Interface Card ...

    • Factory default

      Factory default In general, resets and Factory Defaults for any OMNEO device can be done with Dante Controller. To do a Factory default including or excluding network settings via DANTE Controller: Double click the unit in Dante Controller Select the ...

    • How to get and apply a License on a Keypanel

      How to get and apply a License on a Keypanel Get the MAC address 1. To get the MAC address of the Key panel, enter the menu with the “MENU” button. 2. Select “Display” and press “SEL” 3. Select “MAC Address” and press “SEL” 4. Write down this MAC ...